Fixing Hardware for Outdoor Convex Safety Mirrors

Pipe Clip The MIRAC Safety mirrors come complete with a hot galvanised pipe clip for 50 and 75 mm (2 and 3") posts.

Optional Wall-arm The wall-arm is required if mounted on a wall or other flat surfaces.

Instructions:

1. Unscrew screw A from the back of the mirror.

2. Take out the glass mirror from it's housing.

3. Slide the Auxiliary Mirror on to the conventional mirror's inside housing using the bracket.

4. Using Phillips Screwdriver, tighten screws B & C until bracket tightly clamps to existing mirror's housing.

5. Place Auxiliary Mirror's glass back in it's housing and tighten screw A in the back.

6. Adjust Auxiliary Mirror to desired angle using thumbs.

Fixing Hardware for Indoor Convex Safety Mirrors

The MIRAC Convex Mirrors come complete with a special designed flexible arm for infinite adjustment and wall-fixing inclusive of 4screws and wall-plugs.

300 mm

If required the length of the flexible arm can be prolonged by means of the 100 mm long and stiff extension-arm shown below. Furthermore two armscan be jointed so that the total length of the extension arm is doubled.

100 mm

200 mm

The Convex Mirrors can also be mounted on the power supplying tube, the sign panel or similar by means of the complementaryclamp. The clamp is available with the capacity of 33 mm or 60 mm.